Pipelife Polfix+ UVS clamping block 19 mm black RAL9005

€1.00

A PV installation that looks sleek often stays sleek. With the Pipelife Polfix+ UVS clamping block 19 mm, you firmly secure a 19 mm tube/pipe – so your route won’t slide, rattle or chafe.

This version is black RAL9005 (nice with black cable work) and belongs to the Polfix+ UVS system. MPN 237967, EAN 8718892002737.

For 19 mm outer diameter pipe/duct (please measure = always right).
Sleek black: RAL9005, blends nicely into PV installations
System: Pipelife Polfix+ UVS – MPN 237967 – EAN 8718892002737

MPN: 237967

Bezorging op Monday 23 February — voor €5.74 verzonden (met 0% btw).

100 in stock

Pipelife Polfix+ UVS clamping block 19 mm black RAL9005 (237967)

When your PV installation is soon shining on the roof, you don’t want your pipework to be the weak point. This Polfix+ UVS clamping block 19 mm is just such a “small but essential” component: it holds your 19 mm tube/pipe neatly in place, so that your route stays tight – even after wind, heat and a few seasons of sun.

And yes: it is black RAL9005. That seems cosmetic, but on a roof, it’s secretly quite nice when everything blends nicely between your black cables, roof details and PV stuff.

Why you do want this terminal block (and not tie-wraps)

Peace and quiet in your routing: no sliding pipe, no rattling pieces, less chance of chafing.
Service-friendly: everything remains logical and accessible if you want to touch up, measure or replace later.
Neat = durable: less movement = less mechanical stress on bends, penetrations and connection points.

Note (size = size): “19 mm” is the outside diameter of your pipe/pipe. Measure it. Does it just not fit? Don’t force it: then choose the right size clamping block.

Technical specifications (nice and clear)

Product	Pipelife Polfix+ UVS clamping block
Size	19 mm (outer diameter pipe/duct)
Colour	Black RAL9005
MPN	237967
EAN	8718892002737
Material	Check datasheet
UV resistance (UVS)	Check in datasheet
Indoor/outdoor application	Check in datasheet

Where is it most often used in PV?

Think of everything you like to have “out of the wind” and neatly routed:

Conduit/pipe towards roof penetration or cable tray
Piping along eaves or technical route across the roof
Transitions at bends and height differences (where it will pull otherwise)

Note (system/substrate): This is a clamp block. Exactly how you attach it (carrier/console/substrate, screws/anchors, roof racks, etc.) depends on your Polfix+ assembly. Check in datasheet which combinations are intended.

Installation tips that will save you time (and frustration) later on

1) Route first, then fix

Lay out your route and determine where bends, feed-throughs and branches are located.
Tip: Place a clamp just before and just after a bend or culvert. Then you will not pull on your pipe.

2) Distance between clamps

There is no magic number: distance depends on pipe type,