Growatt APX naar 3-fase omvormer kabel 5m

Growatt APX to 1-phase inverter cable 5m

SKU: 236393

€42.98

Growatt APX to 1-phase Inverter Cable Pre-assembled HV-DC cable set to connect your APX battery system directly to 1-phase Growatt hybrid inverters (MIN XH). Perfect for when the standard supplied 3-metre cable set is just not long enough.
Keyed connectors, correct polarity and a neat, safe installation without pressing or crimping.

MPN: TV03.0011000

Available on back-order

1 stuk
€42.98
5+ stuks
€40.83 (5% off)

Growatt APX → 1-phase Inverter Cable EU 5 m(TV03.0011000)

The Growatt APX to 1-phase inverter cable (EU version, 5 metres) connects your APX HV battery safely and plug-&-play to a 3-phase Growatt hybrid inverter (MIN XH). Perfect for when the standard supplied 3-metre cable set is just not long enough.
The cable set is pre-assembled with factory connectors and designed for high DC voltages and currents of the APX system. Ideal for neat, reliable mounting without crimping or pressing.

Factory pre-assembled

Keyed battery & inverter connectors; correct polarity secured.

5 metres installation flex

Ample length for neat routing in cabinet and along wall/rail.

HV-capable

Double-insulated DC cable designed for APX high-voltage range.

PV installation-proof

Robust jacket, mated IP sealing and strain relief according to guidelines.

Compatibility

  • Growatt APX HV battery system to 1-phase hybrid Growatt inverters.
  • Applicable to MIN XH series.
    Note: not for ARK or 3-phase MOD-XH and MID XH variants.

What’s in the box?

  • APX nar 1-phase inverter DC cable set EU 5 m (part code TV03.0011000)
  • Pre-assembled HV connector(s) on battery side and inverter side
  • Brief connection/safety instructions (pictograms)

Technical data

Length 5 m
Type APX HV battery ↔ 1-phase Growatt hybrid inverter (DC)
Insulation Double insulated, HV rated (APX voltage range)
Connectors Factory connectors, keyed/polarised; mated IP sealing
Environment Indoor/shaded; routing voltage-free and protected
Part code TV03.0011000 (EU cable, 5 m)

Installation tips

  1. Power off – switch off battery stack and inverter according to sequence in manual; wait for DC buses to discharge.
  2. Route & radius – keep minimum bending radius; avoid kinks and sharp edges (use feed-throughs/swivels).
  3. Separation – keep DC battery cables separate from AC cables; fix with cable clamps to prevent movement.
  4. Connector click – insert until full click; check locking and perform pull test.
  5. Polarity – check BAT+ and BAT-; start up only after all terminals/connectors have been checked.
Radiant green tip: Place inverter above or next to APX battery stack for shorter DC routes and less loss.
Is 5 m too tight or just too long? Choose the cable length you can tuck away tightly without loops.
Merk

Growatt
Kiyoh reviews