QuickSlide QS PV roof anchor

Even on difficult roofs with unevenness, a slight slope or where ballasting is not an option, the QS PV anchors offer a solution.
Where it was previously impossible to install solar panels on these roofs, thanks to the QS PV anchors this is now possible!

It can be used for both sloping roofs and flat roofs.

The base set QS PV anchor: you screw this part down with 4 screws through your bitumen and insulation.
You can order this product separately or in a bundle together with the stainless steel M10 collar nut and the Bitumen SBS sleeve (Bauder) v2.

Even on difficult roofs with unevenness, a slight slope or where ballasting is not an option, the QS PV-ankers offer a solution.
Where it was previously not possible to install solar panels on these roofs, thanks to the QS PV-ankers it now is!

The sleeve Bitumen SBS (Bauder) v2 is the part you use once you have fixed the QS PV-anker to your roof.
You heat the underside and stick the part over the QS PV-anker.
You can order this product separately or in a bundle together with the QS PV-anker base set and the stainless steel M10 flange nut.

Please note!!
You can combine the anchor with the F-adapter. In that case you have no warranty on this assembled product, because this combination has not been tested.
You screw the anchor with 4 screws (not included in the quotation) through your bitumen and insulation, through your roof decking. You then place the sleeve over it to make it watertight. A hanger bolt is no longer needed.

Even on difficult roofs with unevenness, a slight slope or where ballasting is not an option, the QS PV-ankers offer a solution.
Previously it was not possible to install solar panels on these roofs, but thanks to the QS PV-ankers it now is!

The flange nut stainless steel M10: you need 2 of these to fasten the clamp or F-adapter to the anchor.
You can order this product separately or in a bundle together with the QS PV-anker basic set and the Bitumen SBS (Bauder) v2 sleeve.

Please note!!
You can combine the anchor with the F-adapter. In that case you have no warranty on this combined product, because this combination has not been tested.
You screw the anchor with 4 screws (not included in the quotation) through your bitumen and insulation, through your roof boarding. You then place the sleeve over it to make it watertight. A hanger bolt is no longer needed.